Subaru Legacy BN/BS (2015-2019) Service Manual: Power amplifier

Installation

1. Install the noise suppressor assembly.Tightening torque:12±3 N·m (1.2±0.3 kgf-m, 8.9±2.2 ft-lb)2. Install the trim panel - rear pillar UPR. (Sedan model) Rear Quarter Trim > INSTALLATION ...

Removal

NOTE:Remove the power amplifier assembly after sliding the passenger’s seat back and forth as necessary.1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the power amplifier ...

Other materials:

Removal
CAUTION:Always use new MT gear select cable if the cable is removed from selector lever COMPL of transmission side.1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the air intake duct. Air Intake Duct > REMOVAL3. Remove the V-belt covers.4. Remove the clip (A) from the air inta ...