Subaru Legacy BN/BS (2015-2019) Service Manual: Pulsation damper

Installation

1. Install the oil temperature sensor to the cylinder block, and connect the connector to the oil temperature sensor.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft-lb)2. Connect the ground termin ...

Removal

WARNING:Place “NO OPEN FLAMES” signs near the working area.1. PULSATION DAMPER RH1. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Ca ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the under cover. Front Under Cover > REMOVAL3. Drain the engine oil. Engine Oil > REPLACEMENT4. Disconnect the oil level switch connector from the engine harness, and remove the clip (A) securing the harness.5. Remove clip (A) f ...