Subaru Legacy BN/BS (2015-2019) Service Manual: Rear axle

Installation

1. Before installation, check the following items, and replace the propeller shaft assembly as necessary.• Dents or cracks on the tube surface• Splines for deformation or abnormal wear&bul ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle, and then remove the rear wheels.3. Remove the nut - axle.CAUTION:Do not loosen the nut - axle while the rear axle is ...

Other materials:

Dtc p0137 o2 sensor circuit low voltage bank 1 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...