Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
• Check the drive plate for wear and damage. • Check the driven plate for discoloration (burnt color). • Check for worn snap ring, fatigue or damaged return spring or deformed piston retainer. • Replace if its tooth surfaces are broken, damaged or excessively worn. • Check the bearing for seizure or wear. • Apply CVTF to bearing and rotate the bearing to check for noise or dragging etc. |
Installation
NOTE:For installation of front reduction driven gear, refer to the “Front Reduction Drive Gear”. Front Reduction Drive Gear > INSTALLATION ...
Disassembly
1. Remove the front reduction driven shaft from the front reduction driven gear.2. Remove the snap ring.3. Remove the retaining plate, drive plate, driven plate and dish plate.4. Remove the seal ring ...
Other materials:
Installation
NOTE:• Use a new gasket.• Be sure to install the clutch hose with the mark side facing upward.• Be careful not to twist the clutch hose during installation.• Before installing the operating cylinder, apply grease to the contact point of the release lever and operating cylinde ...
© 2017-2026 Copyright www.sulegacy.com
