Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Room light / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
1 — 3	Switch OFF	1 M- or more
1 — 3	Switch ON	Less than 1 -
2 — 3	Switch door	Less than 1 -

2. Apply battery voltage between the connector terminals to check the lighting condition of the light.

Terminal No.	Inspection conditions	Specification
3 (+) — 1 (−) 3 (+) — 2 (−)	Switch OFF	Light OFF
	Switch ON	Light ON
	Switch door	Light ON

3. Replace the light assembly - room if the inspection result is not within the standard value.

Removal

NOTE:Do not remove the room light if removing the bulb only.1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the light assembly - room.(1) Remove the clips, and then remove the ho ...

Installation

1. Install the lens and bulb.CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.2. Install the light assembly - room.3. Connect the ground terminal to ba ...

Other materials:

Removal
1. ROCKER COVER RHNOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. When working on the vehicleNOTE:When working on the vehicle, perform the following steps also.(1) Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.(2 ...