Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Room light / Installation

1. Install the lens and bulb.

CAUTION:

Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.

2. Install the light assembly - room.

3. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 3Switch OFF1 M- or moreSwitch ONLess than 1 -2 — 3Switch doorLess ...

Side turn signal light assembly

...

Other materials:

Disassembly
NOTE:• Attach a cloth to the end of driven shaft (on the frictional side of the thrust needle bearing) to prevent damage during disassembly or reassembly.• When replacing the coupling sleeve and synchronizer hub, replace them as a set. Because these must engage at the specified point, av ...