Subaru Legacy BN/BS (2015-2019) Service Manual: Rear drive shaft

Disassembly

1. BUSHING - REAR AXLE HOUSINGDo not remove the housing assembly - rear axle because the bushing - rear axle housing cannot be replaced. If it is removed, replace the housing assembly - rear axle.2. B ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle, and then remove the rear wheels.3. Remove the nut - axle.CAUTION:Do not loosen the nut - axle while the rear axle is ...

Other materials:

Installation
1. Install the unit assembly - AUX.2. Install the pocket assembly - CTR.3. Install the panel center LWR.4. Install the cover assembly - front and the console box assembly.Tightening torque:6.5 N·m (0.6 kgf-m, 4.8 ft-lb)5. Install the heater control assembly.6. Connect the ground terminal to b ...