Subaru Legacy BN/BS (2015-2019) Service Manual: Access buzzer

Immobilizer control module note

For removal/installation procedures of immobilizer control module, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER”. ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the access buzzer.(1) Remove the clips, and turn over the mud guard - front.(2) Disconnect the connector.(3) Remove the clip and d ...

Other materials:

Dtc p0970 pressure control solenoid "c" control circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Drivability getting worse.1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK HARNESS.CAUTION:Start work after ATF cools down.1) Turn the ignition switch to OFF.2) Disconn ...