Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Access buzzer / Inspection

Using the Subaru Select Monitor, perform forced operation of the access buzzer. User Customizing > OPERATION

If the buzzer does not sound, replace the access buzzer.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the access buzzer.(1) Remove the clips, and turn over the mud guard - front.(2) Disconnect the connector.(3) Remove the clip and d ...

Installation

CAUTION:Install the mud guard - front so that the front end of the mud guard (b) comes outside the bumper face - front (a).1. Install the access buzzer.2. Connect the ground terminal to battery sensor ...

Other materials:

Dtc p014c a/f / o2 sensor slow response - rich to lean bank 1 sensor 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.STEPCHECKYESNO1.CHECK EXHAUST SYSTEM.NOTE:Check the foll ...