Subaru Legacy BN/BS (2015-2019) Service Manual: Diagnostic procedure with diagnostic trouble code (dtc)
Subaru Legacy BN/BS (2015-2019) Service Manual / Occupant detection system (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc b1795 occupant detection module internal circuit
- Dtc b1762 occupant detection module calibration not initialized
- Dtc b177e buckle switch range
- Dtc b177d ignition power supply low voltage
- Dtc b177c ignition power supply high voltage
- Dtc b177b buckle switch circuit high
- Dtc b177a buckle switch circuit low
- Dtc b1779 buckle switch circuit open
- Dtc b1778 belt tension sensor control module
- Dtc b1777 belt tension sensor input voltage low
- Dtc b1776 belt tension sensor input voltage high
- Dtc b1775 belt tension sensor output too low
- Dtc b1774 belt tension sensor output too high
- Dtc b1773 belt tension sensor circuit open
- Dtc b1772 occupant detection sensor temperature too low
- Dtc b1770 occupant detection sensor temperature too high
- Dtc b176f occupant detection sensor input voltage low
- Dtc b176e occupant detection sensor gel run out
- Dtc b176d occupant detection sensor input voltage low at ig-sw on
- Dtc b176c occupant detection sensor pressure too high
- Dtc b176b occupant detection sensor pressure too low
- Dtc b176a occupant detection sensor pressure circuit open
- Dtc b1769 occupant detection sensor temperature circuit open
- Dtc b1768 occupant detection module eeprom state
- Dtc b1767 occupant detection module eeprom initializing
- Dtc b1766 occupant detection module stack overflow
- Dtc b1765 occupant detection module rom checksum
- Dtc b1764 occupant detection module calibration uncompleted
- Dtc b1763 occupant detection module calibration checksum
Electrical specification
CAUTION:Never remove the occupant detection control module, occupant detection sensor or seat frame because they are integrated into one unit.Terminal No.Description1Belt tension sensor output2Belt te ...
Dtc b1795 occupant detection module internal circuit
DTC DETECTING CONDITION:When the following DTCs are detected:B1763, B1764, B1765, B1766, B1767, B1768, B1769, B176A, B176B, B176C, B176D, B176E, B176F, B1770, B1772, B1776, B1777, B1778NOTE:DTC B1795 ...
Other materials:
Installation
1. Check and adjust the operating rod of the vacuum booster assembly.(1) Measure the length between the vacuum booster assembly mounting surface and clevis pin hole.(2) If it is not within the specification, loosen the lock nut, rotate the vacuum booster assembly operating rod to adjust the rod leng ...
© 2017-2026 Copyright www.sulegacy.com
