Subaru Legacy BN/BS (2015-2019) Service Manual: Power seat memory system (diagnostics)
Subaru Legacy BN/BS (2015-2019) Service Manual / Power seat memory system (diagnostics)
- Basic diagnostic procedure procedure
- Check list for interview check
- Clear memory mode operation
- Diagnostics with phenomenon inspection
- Electrical component location location
- Inspection mode procedure
- List of diagnostic trouble code (dtc) list
- Read diagnostic trouble code (dtc) operation
- Control module i o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc b2606 power seat position sensor circuit low
- Dtc b2600 lin communication
- Dtc b2605 battery control low
- Dtc b2604 power seat memory eeprom
- Dtc b2603 epb control
- Dtc b2602 vehicle speed control
- Dtc b2601 lin circuit low
- Freeze frame data display
- General description
- Read current data
- Subaru select monitor
Inspection
1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness. ...
Basic diagnostic procedure procedure
STEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer the condition of how the trouble occurred.Did you interview the customer- Basic Diagnostic Procedure > P ...
Other materials:
Road test inspection
NOTE:Turn OFF the X mode switch and perform inspection.1. GENERAL PRECAUTIONRoad tests should be conducted to properly diagnose the condition of CVT.CAUTION:Always observe the local traffic laws when performing the test.2. D RANGE SHIFT FUNCTIONMake sure that the engine speed is 1,100 — 1,300 r/mi ...
© 2017-2026 Copyright www.sulegacy.com
